![]() A small block of wood, somewhere around 1 to 2 inches and some course sandpaper.Option: Joe Porper's Little Shaver, about 16 bucks. A single edge razor blade or a X-acto knife.Required tools you may already have, with some options: Your tip should be around a buck, providing you don't buy a layered tip. While you are there be sure to pick up one of your favorite tips, make sure that it is larger than the rod you bought, because it is easier to glue on an oversize tip and trim it down than it is to glue a tip that's the same size on perfectly center. I have used it for several years and if used correctly it holds very well, if not better than Super Glue and I have never had it dry in the tube. I would visit your local billiard supply store and buy a tube of Tweeten's 10 Minute Cement. It may also only work once since the next time you need it, it will most likely have dried in the tube. I don't recommend Super Glue simply because it does not give you a lot of time to work with the tip. The most common glue used is Super Glue, all most always Gel. If you choose something that is close to the length of your shaft it will be easier to work with. Picking one out the same diameter as your shaft should be a simple task, but don't pick out something that is only a few inches long. ![]() You should be able to find them 2 to 3 foot long and in just about any diameter. The first thing you need to do for this test is to go to the local hobby shop or hardware store and buy a wooden rod, be sure the ends are square. Tip replacement is not that difficult and if proper time and care are taken, then tips can be easily replaced. I will also recommend some inexpensive tools that will help to do a quicker and possibly a little better quality job. This test will not involve any risk to your cue and you can do this test with the required tools for about 5 bucks, assuming you have a few common tools around the house. If you don't break with your cue, then you might use it until it is the thickness of 1 Nickel.ĭO NOT USE YOUR CUE FOR THIS TEST, this test is only to see if you are capable and willing to do the job. If you break with your cue, then I would not let the base of the tip (The Side) get much under the thickness of 2 Nickels or you risk damage to the ferrule. You will get a lot of opinions on when a tip needs to be replaced, so I will give you my recommendation. Over the years, my methods have changed and what follows are the best of those methods in a test that I have created to see if you are capable and willing to replace your own tip. I was taught to replace my own tip the first time it was needed. I have always felt that if a player wants to replace their own tips, then they should learn to do so. Players that want to know how to replace their own tips is sometimes a controversial issue.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |